HelioAim guide

True North vs Magnetic North for Solar Panels

Understand why a compass bearing can differ from a solar azimuth, how east and west declination affect the conversion, and how to set a true direction on site.

Updated

A solar design may specify a panel direction such as 180° true, while a handheld compass points to magnetic north. The angle between those north references is called magnetic declination. It changes with location and slowly over time, so a compass bearing and a map or solar-tool azimuth can differ even when both are correct in their own reference system. NOAA’s National Centers for Environmental Information (NCEI) defines east declination as positive and west declination as negative. NOAA NCEI: Magnetic Declination

Convert a compass bearing to true azimuth

Use this convention, with east declination positive and west declination negative:

True azimuth = magnetic compass bearing + declination

Normalize the result to 0°–360° if it crosses north. For example, if declination is 8° east and a compass reads 172°, then 172° + 8° = 180° true. If declination is 8° west, treat it as −8°: 172° + (−8°) = 164° true. NOAA NCEI gives the same add-declination correction and sign convention. NOAA NCEI declination guidance

Local declinationCompass bearingConverted true azimuth
8° east (+8°)172° magnetic180° true
8° west (−8°)188° magnetic180° true

These are arithmetic examples, not declination values for any particular place. Get the current value for the installation’s coordinates and date from an authoritative geomagnetic calculator.

Convert a desired panel direction to a compass target

If the design calls for a true azimuth and you are turning a compass on site, rearrange the formula:

Magnetic compass target = desired true azimuth − declination

Suppose the array should face 180° true. With 8° east declination, the compass target is 180° − 8° = 172° magnetic. With 8° west declination (−8°), it is 180° − (−8°) = 188° magnetic. This lets the panel’s physical direction match the true-north design value even though the compass needle follows the local magnetic field.

Get declination for the site

  1. Use the installation coordinates, not a distant city if the site is far away.
  2. Use a current geomagnetic model or a dated field value. NOAA NCEI’s calculator provides declination for a location and date; its result is modeled, not a correction for nearby steel or electrical equipment. NOAA NCEI declination calculator
  3. Check whether the source reports east-positive or uses another sign convention before applying the formula.
  4. Keep the reference attached to the number: write “180° true” or “172° magnetic,” not just “180°.”

Do not confuse declination with a bad compass reading

Declination is the predictable difference between true and magnetic north at a given place and time. A nearby steel roof, mounting rail, vehicle, speaker, or current-carrying wire can disturb the compass reading locally; applying declination does not remove that interference. If readings change as you move the phone or rotate it near the installation, first move away from possible magnetic sources and check again. The next guide covers why phones can be unreliable near metal.

Use the same north reference throughout

HelioAim azimuths and the Sun position calculator use true north. The solar panel azimuth guide explains the direction-to-degree convention. When transferring a target to a physical roof, apply the site’s declination to a magnetic compass bearing, then consider local interference and verify the installation direction with an appropriate method.