A clear, straight shadow can give you a north-south reference without relying on a phone compass. The reliable cue is local solar noon, when the Sun crosses your location’s meridian. A vertical object’s shadow then lies along the north-south line. NOAA defines solar noon by that meridian crossing and notes that the shadow points north or south depending on latitude and season. NOAA Global Monitoring Laboratory: solar calculator glossary
What you need
- A straight stick or pole that can stand vertical;
- a level, reasonably flat surface with direct sunlight;
- chalk, tape, or small markers to mark the shadow tip;
- the local solar-noon time for the date and location, from a current sun-position tool or a reliable solar table.
Mark the noon shadow
- Choose an open spot where the Sun will not be blocked around noon. Avoid a surface that slopes or changes height beneath the stick.
- Stand the stick as vertically as you can. A plumb line or a level in two directions helps; a leaning stick shifts the shadow direction.
- Find local solar noon for your coordinates and date. It is not necessarily 12:00 on the clock: longitude within the time zone, the equation of time, and daylight saving time affect the clock reading. NOAA’s calculation details describe solar noon as a function of longitude and the equation of time. NOAA solar calculation details
- At solar noon, mark the base of the stick and the tip of its shadow. Draw a straight line through the two marks. That line is the local meridian, running north-south.
- Identify which end is north using the Sun’s side at noon and your location and season; do not assume the shadow always points north.
| Noon Sun position | Shadow points | Typical situation |
|---|---|---|
| Sun due south | North | Most Northern Hemisphere locations outside the tropics |
| Sun due north | South | Most Southern Hemisphere locations outside the tropics |
| Sun near overhead | Short and difficult to read | Tropical locations near dates when the Sun passes close to zenith |
| Sun on the opposite side at noon | Reversed from the usual local pattern | Some tropical locations and seasons |
Worked direction example
Suppose a Sun-position tool reports a true solar azimuth of 140° at the observation time. The shadow points in the opposite horizontal direction: 140° + 180° = 320° true (normalize angles to 0°–360°). That gives a northwest-pointing shadow; the opposite end of the same line points southeast at 140° true. This worked example shows the direction conversion; a near-noon observation should be close to north-south only when the Sun is near the local meridian.
For the cleanest north-south result, use the Sun’s meridian crossing rather than a time that merely looks like noon on your clock. If you are observing earlier or later, the shadow will generally not lie on the meridian.
Why clock noon is not solar noon
Clock time is standardized across a time zone, while solar noon depends on the exact longitude and the Sun’s apparent motion through the year. NOAA’s glossary describes the equation of time as a cause of solar-noon time changing through the year, and its solar calculation notes include longitude and the equation of time in the calculation. Use the local date and coordinates when finding the observation time. U.S. Naval Observatory: equation of time
Limits and safer checks
- Clouds or a fuzzy shadow: wait for a sharper shadow; an indistinct tip makes the line hard to place.
- Very short shadow: near overhead Sun, small placement errors cause large direction changes. Observe on another date or use a different method.
- Uneven ground or a tilted stick: correct the setup before trusting the line.
- Direction matters: the shadow gives a meridian line, but which endpoint is true north depends on where the Sun is at noon. In tropical regions that can change with season.
- Solar safety: observe the ground shadow; never look directly at the Sun.
The Sun position calculator reports true azimuth for a selected place and time and can help check which way the shadow should fall: it is opposite the Sun’s horizontal direction. For a panel installation, keep the azimuth labeled “true,” and compare the field line with the roof and mounting layout before treating it as a final alignment.