HelioAim guide

Why Your Phone Compass Is Wrong Near Metal

Learn why a phone compass can swing near a metal roof or solar mount, how to tell interference from magnetic declination, and how to check a direction more reliably.

Updated

A phone compass estimates direction from magnetic-field sensors. Android describes its geomagnetic sensor as measuring the ambient magnetic field on three axes, and its sensor reference notes that magnetized iron, steel, or permanent magnets can distort magnetic readings. A steel roof, mounting rail, vehicle, magnet, or nearby electrical equipment can therefore pull the reading away from the Earth-field direction. Android sensor overview · Android magnetic-field sensor reference

Declination and interference are different problems

Magnetic declination is the expected angle between true north and magnetic north for a location and date. Nearby metal or electrical currents can instead distort the local field around the phone. Declination can convert a stable magnetic bearing to true azimuth; it cannot repair a bearing that is changing because the sensor is sitting in a disturbed field. Read how to apply declination.

What you noticePossible explanationWhat to try
Heading shifts near roof rails, a vehicle, or a toolLocal magnetic interferenceMove several steps away from metal and compare again
Heading is steady, but differs from a true-north map directionMagnetic declination or a reference mismatchCheck whether each value is magnetic or true, then apply local declination
Heading jumps while the phone rotates or tiltsSensor calibration, device orientation, or nearby interferenceFollow the phone’s calibration prompt and recheck in an open area
Different devices disagree only at the installation pointLocal field disturbance or device-specific sensor behaviorCompare away from the installation and use an independent reference

A quick field check

  1. Take the phone away from the roof, steel rack, car, tools, speakers, magnets, and powered cables. Do not rest it on the panel or mounting frame.
  2. Hold it flat and still, then note the heading. Follow the device’s own calibration instructions if it reports a calibration problem.
  3. Turn slowly through a full circle. The reading should change smoothly; sudden jumps or a different result when you return to the same direction suggest the location or sensor needs another check.
  4. Repeat the measurement at a second nearby open spot. If the two spots disagree, do not assume the larger or more convenient number is correct.
  5. Use a current declination for the site to convert a reliable magnetic bearing into true azimuth. Keep the result labeled as true or magnetic.

Why moving the phone can help

Magnetic-field sensors respond to the field at the phone, not to a panel’s intended direction. A small change in position can move the sensor closer to or farther from a steel support or current-carrying conductor, changing the measured field. Calibration may compensate for some device-related sensor biases, but it cannot make a disturbed location equivalent to an undisturbed one. Android’s uncalibrated sensor documentation specifically describes hard-iron distortion from magnetized iron, steel, and permanent magnets. Android Sensor API reference

When a phone compass is not enough

For a rough orientation check, repeatable readings away from interference may be useful. For a permanent solar installation, use a survey or layout method appropriate to the site and verify the panel direction against a true-north reference. A phone reading beside the metalwork is not a reliable measurement of true azimuth.

The Sun position calculator reports the Sun’s true azimuth for a selected place and time; it does not read the phone’s compass or measure nearby metal effects. Continue to true north vs magnetic north for the bearing conversion, or use the upcoming Sun-and-shadow guide for a compass-independent orientation check.